2007 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

2GR-FSE Engine Mechanical: Equipment

2GR-FSE ENGINE MECHANICAL - EQUIPMENT

Abrasive compound -
Brush -
Caliper gauge -
Carbide cutter (30Β°) -
Carbide cutter (45Β°) -
Carbide cutter (60Β°) -
Carbide cutter (75Β°) -
CO/HC meter -
Compression gauge -
Connecting rod aligner -
Cylinder gauge -
Dial indicator -
Dye penetrant -
Engine tune-up tester -
Groove cleaning tool -
Heater -
Engine Stand -
Micrometer -
Pin hole grinder -
Piston ring compressor -
Piston ring expander -
Plastigage -
Precision straight edge -
Press -
Reamer (5.5 mm) -
Ridge reamer -
Soft brush -
Solvent -
Spring tester -
Steel square -
Thermometer -
Torque wrench -
Valve seat cutter -
Valve guide bushing brush -
V-block -
Vernier calipers -
Wire brush -
Wooden block -
Torx socket wrench -

HINT:

Torx is registered trademark of Textron Inc.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.