2007 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

  1. INSPECT DEFOGGER RELAY (Marking: DEFOG) 
    1. Measure the resistance of the DEFOG relay.

      Standard 

      DEFOGGER RELAY

      Tester Condition Specified Condition
      3 - 4 Below 1 ohms (when battery voltage is not applied between terminals)
      3 - 5 10 k ohms or higher (when battery voltage is not applied between terminals)
      3 - 5 Below 1 ohms (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay. 

    Fig 1: Inspecting Defogger Relay (Marking: Defog)
    G04050798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.