Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GX 470FACTORY OEM SERVICE PROCEDURE
Engine Control System - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection, Installation: ECM: Installation
- INSTALL ECM
- Install the ECM bracket No. 2 with the 2 screws to the ECM.
- Install the ECM bracket No. 1 with the 2 screws to ECM.
- Install the ECM with the 3 nuts.
Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
- Connect the 5 ECM connector.
- INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY
- INSTALL INSTRUMENT PANEL ORNAMENT
- INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
