Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GX 470FACTORY OEM SERVICE PROCEDURE
Fuel Injector: Installation
- INSTALL FUEL INJECTOR ASSEMBLY
- Install a new grommet and insulator to the injector.
- Check that there is no foreign object or damage to the groove of the O-ring of the injector. Apply gasoline to a new O-ring, and install it to the injector.
- Install the injector to the delivery pipe while turning the injector in both ways.
- Check that the injector can turn smoothly.
NOTE: When the injector cannot turn smoothly, the O-ring might be caught in something. In that case, replace the O-ring with a new one.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
