Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GX 470FACTORY OEM SERVICE PROCEDURE
2UZ-FE Engine Mechanical: Equipment
2UZ-FE ENGINE MECHANICAL - EQUIPMENT TABLE
| Reamer |
| V-block |
| Piston ring compressor |
| Piston ring expander |
| Valve seat cutter |
| CO/HC meter |
| Compression gauge |
| Connecting rod aligner |
| Cylinder gauge |
| Feeler gauge |
| Micrometer |
| Precision straight edge |
| Radiator cap tester |
| Steel square |
| Tachometer |
| Torque wrench |
| Vernier calipers |
| Dial indicator with magnetic base |
| OBD II scan tool |
| Engine Sling Device |
| Chain Block |
| Spring tester |
| Plastigage |
| Heater |
| Universal engine lifter |
| Plastic Hammer |
| Press |
| Timing light |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
