Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Lexus GX 470FACTORY OEM SERVICE PROCEDURE

Rear Speed Sensor: Removal

HINT:

Replacement of RH side is same as that of LH side.

REMOVE REAR WHEEL
REMOVE SPEED SENSOR REAR LH

Fig 1: Identifying Speed Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the speed sensor connector.
2. Remove the nut and speed sensor rear from the axle hub.
  NOTE:
  - Do not stick and foreign matter on the sensor tip.
  - Do not let the foreign matter into the sensor installation hole.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.