2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE

Fuel Tank: Installation

  1. INSTALL FUEL TANK CUSHION 
    1. Install the tank cushion and tank protector.
      Fig 1: Identifying Tank Cushion And Tank Protector
      G05303311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 11 tank cushions.
      Fig 2: Identifying Tank Cushions
      G05303310Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FUEL TANK VENT HOSE SUB-ASSEMBLY 
    1. Install the vent hose to the fuel tank.

      HINT:

      Push the parts together firmly until a "click" sound is heard.

      NOTE:
      • Before installing the tube connectors to the pipes, check if there is any damage or foreign matter in the connectors.
      • After the connection, check if the connectors and pipes are securely connected by trying to pull them apart.
        Fig 3: Identifying Vent Hose To Fuel Tank
        G05303314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY 
    1. Attach the 2 claws to the claw holes and install a new edge protector.
      Fig 4: Installing Edge Protector
      G05303315Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the clamp, fuel tank main tube and return tube.
      Fig 5: Locating Fuel Tank Main Tube, Clamp And Return Tube
      G05303307Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL FUEL TANK TO CANISTER TUBE SUB-ASSEMBLY 
    1. Install a new gasket and the canister tube with the 4 screws.

      Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) 

      Fig 6: Locating Canister Tube With Screws
      G05303306Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL FUEL TANK WIRE 
    1. Install the tank wire with the 7 clamps.
      Fig 7: Locating Tank Wire With Clamps
      G05303305Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL FUEL TANK VENT TUBE SET PLATE  (See INSTALLATION )
  7. INSTALL FUEL TANK PRESSURE SENSOR  (See INSTALLATION )
  8. INSTALL NO. 3 FUEL TANK PROTECTOR  (See INSTALLATION )
  9. INSTALL FUEL TANK SUB-ASSEMBLY 
    1. Set the fuel tank on a mission jack and raise the fuel tank.
    2. Install the clamp, and connect the fuel filler pipe to the fuel tank.
      Fig 8: Installing Clamp
      G05303319Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.