2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Sensor: Inspection

  1. INSPECT FUEL PRESSURE SENSOR 
    1. Check the fuel pressure sensor output voltage.
      1. Apply 5 V between terminals 3 (VC) and 1 (E2).
      2. Measure the voltage between terminals 2 (PR) and 1 (E2).

        Standard voltage: Approximately 0.5 V 

        HINT:

        The above voltage is output when pressure is not applied (0 kPa (0 kgf/cm2 )) to the sensor.

        Fig 1: Identifying Fuel Pressure Sensor Connector Terminal
        G05303205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.