2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE

Fuel Injector (For Direct Injection), Intake Manifold: Inspection

  1. INSPECT FUEL INJECTOR ASSEMBLY 
    NOTE: This inspection aims at inspecting the fuel injectors for opens or shorts, because the fuel injectors of this vehicle are a high-pressure type and cannot be inspected for fuel injection volume.
    1. Check the resistance of the injector.

      Standard resistance 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 2.01 to 2.31 Ω

      If the result is not as specified, replace the injector.

      Fig 1: Checking Resistance Of Injector
      G04947910Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.