Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE
Problem Symptoms Table
HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to the system before inspecting the suspected areas below.
Push-button start
SYMPTOM CHART
| Symptom | Suspected area | See |
|---|---|---|
| Power Source Mode does not Change | 1. B2271 | DTC B2271 IGNITION HOLD MONITOR MALFUNCTION |
| 2. B2272 | DTC B2272 IGNITION 1 MONITOR MALFUNCTION | |
| 3. B2273 | DTC B2273 IGNITION 2 MONITOR MALFUNCTION | |
| 4. B2274 | DTC B2274 ACC MONITOR MALFUNCTION | |
| 5. B2278 | DTC B2278 POWER SWITCH CIRCUIT MALFUNCTION | |
| 6. Power Switch Indicator Circuit | POWER SWITCH INDICATOR CIRCUIT | |
| 7. Room Oscillator does not Recognize Key | ROOM OSCILLATOR DOES NOT RECOGNIZE KEY | |
| 8. Power Switch | REMOVAL | |
| 9. ID Code Box | - | |
| 10. Key | - | |
| 11. Certification ECU | - | |
| 12. Power Source Control ECU | - | |
| 13. Wire Harness | POWER SOURCE MODE DOES NOT CHANGE | |
| Power Source Mode does not Change to ON (READY) | 1. DTC for Smart Access System with Push-button Start | DIAGNOSTIC TROUBLE CODE CHART |
| 2. Power Source Mode does not Change | POWER SOURCE MODE DOES NOT CHANGE | |
| 3. Engine Immobiliser System | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 4. Electric Steering Lock | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 5. Hybrid Control System | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 6. SFI System | HOW TO PROCEED WITH TROUBLESHOOTING | |
| 7. Power Switch | REMOVAL | |
| 8. Power Source Control ECU | - | |
| 9. Wire Harness | POWER SOURCE MODE DOES NOT CHANGE TO ON (READY) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
