2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK FOR DTC 
    1. Delete the DTCs.

      HINT:

      After all DTCs are cleared, check if the trouble occurs again 5 seconds after the power switch is turned ON (IG).

    2. Check for DTCs again.

      OK: No DTC is output. 

    NG:  GO TO DTC CHART 

    OK: GO TO Next Step 

  2. CHECK BASIC FUNCTION 
    1. When the key is inside the vehicle and the shift lever position is in P, check that depressing the brake pedal causes the power switch indicator to illuminate green.

      Result 

      RESULT REFERENCE

      Result Proceed to
      Indicator illuminates green A
      Power switch indicator circuit is normal but indicator does not illuminate green B
      Room oscillator recognizes key but indicator does not illuminate green C

    B:  GO TO ROOM OSCILLATOR DOES NOT RECOGNIZE KEY

    C:  GO TO POWER SWITCH INDICATOR CIRCUIT 

    A: REPLACE POWER SOURCE CONTROL ECU 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.