Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE
Power Switch: Installation
- INSTALL POWER SWITCHÂ
- Attach the 2 claws to install the switch.
- Connect the switch connector.
- INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLYÂ (See INSTALLATION )
- INSTALL INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLYÂ (See INSTALLATION )
- INSTALL INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLYÂ (See INSTALLATION )
- INSTALL INSTRUMENT SIDE PANEL LHÂ (See INSTALLATION )
- INSTALL FRONT DOOR OPENING TRIM COVER LHÂ (See INSTALLATION )
- INSTALL FRONT DOOR SCUFF PLATE LHÂ (See INSTALLATION )
- INSTALL INSTRUMENT PANEL FINISH PANEL END LHÂ (See INSTALLATION )
- INSTALL CONSOLE UPPER PANEL ASSEMBLYÂ (See INSTALLATION )
- INSTALL FRONT CONSOLE UPPER PANEL GARNISHÂ (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINALÂ
- PERFORM INITIALIZATIONÂ
- Perform initialization (see
INITIALIZATION (2006/02-2006/07)
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see
INITIALIZATION (2006/02-2006/07)
).
- CHECK SRS WARNING LIGHTÂ
- Check the SRS warning light (see DIAGNOSIS SYSTEM (2006/02-2006/07) ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
