2007 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE

Brake Control Power Supply: Inspection

  1. CHECK BRAKE CONTROL POWER SUPPLY ASSEMBLY 
    1. Check the brake control power supply. If any of the following occurs, replace the brake control power supply assembly with a new one:
      • The surface of the brake control power supply is cracked, dented, or chipped.
      • The connector is scratched, cracked, or damaged.
      • The brake control power supply has been dropped.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.