Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK MANUAL UP / DOWN FUNCTION (DRIVER SIDE)
- Check that the manual UP / DOWN functions operate normally.
OK:
Manual UP / DOWN functions operate normally.
NG: OTHER PROBLEM
OK: GO TO Next Step
- Check that the manual UP / DOWN functions operate normally.
- CHECK LIGHT OF MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (AUTO LIGHT)
- Turn the power switch ON (IG).
- Operate the master switch's driver side switch for 2 seconds or more.
- Check the blinking pattern of the AUTO light. Compare the blinking pattern with the illustration below.
Result
RESULT REFERENCEBlinking Pattern Proceed to 1 or 3 A 2 B 4 C
B: GO TO step 4
C: REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
A: GO TO Next Step
- RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
- Check that the power window operates normally after the reset.
OK:
Power window operates normally.
OK: END
NG: GO TO Next Step
- Check that the power window operates normally after the reset.
- CHECK WIRE HARNESS (POWER WINDOW MASTER SWITCH - POWER WINDOW MOTOR)
- Disconnect the Q13 master switch connector.
- Disconnect the M11 power window motor connector.
- Measure the resistance of the wire harness side connectors.
Standard resistance
TESTER CONNECTION AND SPECIFIED CONDITIONTester Connection Specified Condition Q13-19 (VCC) - M11-4 (SSRB) Below 1 Ω Q13-5 (PLS1) - M11-5 (PLS) Below 1 Ω Q13-15 (PLS2) - M11-3 (PLS2) Below 1 Ω Q13-12 (SGND) - M11-6(E) Below 1 Ω Q13-19 (VCC) or M11-4 (SSRB) - Body ground 10 kΩ or higher Q13-5 (PLS1) or M11-5 (PLS) - Body ground 10 kΩ or higher Q13-15 (PLS2) or M11-3 (PLS2) - Body ground 10 kΩ or higher Q13-12 (SGND) or M11-6 (E) - Body ground 10 kΩ or higher
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Driver Side)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
