2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Floor Shift Assembly: Installation

  1. INSTALL FLOOR SHIFT ASSEMBLY 
    1. Install the floor shift assembly with the 4 bolts.

      Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf) 

    2. Connect the connector to the floor shift assembly.
    Fig 1: Locating Floor Shift Assembly Bolts
    G05288268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Install the floor shift gear shifting rod sub-assembly with the nut.

      Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) 

    Fig 2: Locating Floor Shift Gear Shifting Rod Nut
    G05295396Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. ADJUST SHIFT LEVER POSITION (See  ADJUSTMENT  ) 
  5. INSPECT SHIFT LEVER POSITION (See  ON-VEHICLE INSPECTION  ) 
  6. INSTALL FRONT FLOOR HEAT INSULATOR NO.1 (See  INSTALLATION  ) 
  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY 

    (See INSTALLATION )

  8. INSTALL NO.2 CONSOLE BOX DUCT (See  INSTALLATION  ) 
  9. INSTALL CONSOLE BOX (See  INSTALLATION  ) 
  10. INSTALL CONSOLE BOX REGISTER ASSEMBLY (See  INSTALLATION  ) 
  11. REMOVE CONSOLE BOX PLATE (See  INSTALLATION  ) 
  12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See  INSTALLATION  ) 
  13. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See  INSTALLATION  ) 
  14. INSTALL CONSOLE UPPER PANEL ASSEMBLY (See  INSTALLATION  ) 
  15. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See  INSTALLATION  ) 
  16. PERFORM INITIALIZATION 

    (See INITIALIZATION )

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.