Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE
Floor Shift Assembly: Inspection
- INSPECT TRANSMISSION CONTROL SWITCH
- Connect the park/neutral position switch connector.
Standard resistance
RESISTANCE SPECIFICATIONShift Position Tester Connection Specified Condition S, "+" and "-" 3 - 7 Below 1 Ω Except S, "+" and "-" ↑ 10 kΩ or higher - Disconnect the transmission control switch connector of shift lock control unit assembly.
- Measure resistance according to the value (s) in the table below when the shift lever is moved to each position.
- Connect the park/neutral position switch connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
