2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Front Acceleration Sensor: Removal

NOTE:
  • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
  • The acceleration sensor removed from the vehicle must not be placed upside down.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT DOOR SCUFF PLATE LH (See  REMOVAL  ) 
  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE FRONT DOOR OPENING TRIM COVER LH (See  REMOVAL  ) 
  5. REMOVE FRONT ACCELERATION SENSOR ASSEMBLY 
    1. Disconnect the sensor connector.
    2. Remove the nut and acceleration sensor.
      Fig 1: Locating Acceleration Sensor Assembly
      G05296517Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT ACCELERATION SENSOR 
    1. Remove the nut and sensor from the bracket.
      Fig 2: Locating Acceleration Sensor
      G05296518Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.