Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE
Front Acceleration Sensor: Installation
NOTE:
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
- The acceleration sensor removed from the vehicle must not be placed upside down.
- INSTALL FRONT ACCELERATION SENSOR
- Install the acceleration sensor to the bracket with the nut.
Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
NOTE: Do not drop the sensor. If it is dropped, replace it with a new one.
- Install the acceleration sensor to the bracket with the nut.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
