2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Front Acceleration Sensor: Inspection

  1. INSPECT FRONT ACCELERATION SENSOR 
    1. Connect 3 1.5 V dry batteries in series.
    2. Connect terminal 3 (SGB) to the battery's positive (+) terminal, and terminal 2 (SGG) to the battery's negative (-) terminal.
    3. Measure the voltage of the sensor.

      Standard voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Sensor Condition Specified Condition
      SGFL (1) - SGG (2) Sensor stationary Approx. 2.3 V
      SGFL (1) - SGG (2) Sensor vibrating vertically Change between approx. 1.0 to 4.0 V
      NOTE:
      • Do not apply a voltage of more than 6 V.

      HINT:

      When the acceleration sensor is tilted, it may output a different value.

    Fig 1: Connecting Terminal 3 (SGB) To Battery'S Positive Terminal, And Terminal 2 (SGG) To Battery's Negative Terminal
    G05296519Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.