2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Absorber Control Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (See  REMOVAL  ) 
  3. REMOVE CONSOLE UPPER PANEL ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See  REMOVAL  ) 
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See  REMOVAL  ) 
  6. REMOVE CONSOLE BOX PLATE (See  REMOVAL  ) 
  7. REMOVE ABSORBER CONTROL SWITCH 
    1. Detach the 2 claws and remove the absorber control switch from the console box plate.
      Fig 1: Identifying Absorber Control Switch Claws
      G05296563Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.