2007 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Absorber Control Switch: Inspection

  1. INSPECT ABSORBER CONTROL SWITCH 
    1. Measure the resistance of the switch.

      Standard resistance 

      RESISTANCE REFERENCE CHART

      Tester Connection Switch Condition Specified Condition
      3 - 4 NORM 10 kΩ or higher
      3 - 4 SPORT Below 1 Ω
      Fig 1: Identifying Absorber Control Switch Connector Terminal
      G05296564Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.