Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- POWER WINDOW REGULATOR MOTOR
- Reset the applicable power window regulator motor.
- Check that the power window AUTO UP/DOWN function operates normally.
OK:
AUTO UP/DOWN function operates normally.
NG: OTHER PROBLEM
OK: Go to next step
- CHECK JAM PROTECTION FUNCTION OPERATING RANGE
- Check that the jam protection function operates normally for applicable power window.
HINT:
The jam protection function does not operate from the fully closed position of the door glass to 4 mm (0.16 in.) below that.
OK:
Jam protection function operates normally.
NG: REPLACE SWITCH
OK: END
- Check that the jam protection function operates normally for applicable power window.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.