Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus GS 350 AWDFACTORY OEM SERVICE PROCEDURE
Back Window Glass: Installation
- INSTALL NO. 2 WINDSHIELD GLASS STOPPERÂ
- Apply Primer G to the glass where the spacers will be installed.NOTE:
- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover primer.
- Do not apply too much primer.
- Install 2 new stoppers onto the glass as shown in the illustration.
SpecificationÂ
AREA MEASUREMENT CHARTArea Measurement a 13.0 mm (0.512 in.) b 40.0 mm (1.575 in.)
- Apply Primer G to the glass where the spacers will be installed.
- INSTALL NO. 1 WINDSHIELD GLASS STOPPERÂ
- Install 2 new stoppers to the vehicle body as shown in the illustration.
- INSTALL BACK WINDOW GLASS DAMÂ
- Apply Primer G to the glass where the dams will be installed.NOTE:
- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover primer.
- Do not apply too much primer.
- Apply Primer G to the glass where the dams will be installed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
