2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Shift Lever: Removal

  1. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  2. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE UPPER CONSOLE PANEL ASSEMBLY WITH FRONT ASH RECEPTACLE  (See REMOVAL )
  5. REMOVE HEATER SEAT SWITCH CONSOLE BASE (w/o Seat Heater System)  (See REMOVAL )
  6. REMOVE HEATER SEAT SWITCH CONSOLE BASE (w/ Seat Heater System)  (See REMOVAL )
  7. REMOVE CONSOLE BOX POCKET  (See REMOVAL )
  8. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  9. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE REAR CONSOLE BOX ASSEMBLY  (See REMOVAL )
  11. REMOVE NO. 2 CONSOLE BOX DUCT  (See REMOVAL )
  12. REMOVE NO. 3 CONSOLE BOX DUCT  (See REMOVAL )
  13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Disconnect the end of the transmission control cable from the shift lever assembly.
    2. Disconnect the transmission control cable assembly from the shift lever assembly while pushing the 2 claws of the floor shift cable.
      Fig 1: Disconnecting End Of Transmission Control Cable From Shift Lever Assembly
      G05249595Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE SHIFT LEVER ASSEMBLY 
    1. Disconnect the shift lock control ECU connector and transmission control switch wire connector.
      Fig 2: Identifying Shift Lock Control ECU Connector And Transmission Control Switch Wire Connector
      G05249662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and shift lever assembly.
      Fig 3: Locating Shift Lever Assembly Bolts
      G05249663Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.