Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE
Service Data
| Front wheel alignment | Toe-in (total) | |
| A - B | 0 +- 2 mm (0 - 0.08 in.) | |
| Rack end length difference | 1.5 mm (0.059 in.) or less | |
| Front wheel alignment | Vehicle height | |
| Front A - B | 126 mm (4.96 in.) | |
| Rear C - D | 57 mm (2.24 in.) | |
| Front wheel alignment | Wheel turning angle | |
| Inside wheel | 38°31' +- 2 (38.520 +- 2°) | |
| Outside wheel reference | 33°43' (33.72°) | |
| Front wheel alignment | Camber | |
| Camber | -0°43' +- 45' (-0.72° +- 0.75°) | |
| Right-left difference | 45' (0.75°) or less | |
| Front wheel alignment | Caster | |
| Caster | 2°57' +- 45' (2.95° +- 0.75°) | |
| Right-left difference | 45' (0.75°) or less | |
| Front wheel alignment | Steering axis inclination | |
| Steering axis inclination | 12°20' +- 45' (12.33° +- 0.75°) | |
| front lower ball joint | Lower ball joint turning torque | 1.0 to 3.4 N*m (10 to 35 kgf*cm, 9 to 30 in.*lbf) |
| front stabilizer link assembly | Stabilizer link ball joint turning torque | 0.05 to 2.0 N*m (0.5 to 20 kgf*cm, 0.4 to 18 in.*lbf) |
| Rear wheel alignment | Toe-in (total) | |
| A + B | 0° +- 24' (0° +- 0.4°) | |
| C - D | 4 +- 2mm (0.16 +- 0.08 in.) | |
| Rack end length difference | 1.5 mm (0.06 in.) or less | |
| Rear wheel alignment | Camber | |
| Camber | -1°21' +- 45'(-1.35° +- 0.75°) | |
| Right-left difference | 45' (0.75°) or less | |
| Rear stabilizer link assembly | Stabilizer link ball joint turning torque | 0.05 to 1.0 N*m (0.5 to 10 kgf*cm, 0.4 to 8.9 in.*lbf) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
