Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE
Torque Specifications
STEERING COLUMN ASSEMBLY
STEERING COLUMN - TORQUE SPECIFICATIONS
| Part tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Steering intermediate shaft assembly x Steering column assembly | 35 | 360 | 26 |
| Steering column assembly set nuts | 21 | 214 | 16 |
| Steering column assembly set bolt | 21 | 214 | 16 |
| Steering intermediate shaft assembly x Power steering link assembly | 35 | 360 | 26 |
| Front wheel LH set nuts | 103 | 1,050 | 76 |
| Lower steering column cover x Upper steering column cover | 2.0 | 20 | 18 in.*lbf |
| Steering wheel assembly set nut | 50 | 510 | 37 |
| Multiplex tilt and telescopic ECU set screws | 1.5 | 15 | 13 in.*lbf |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
