2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Service Data

POWER STEERING FLUID 

POWER STEERING FLUID - SERVICE DATA

Fluid level rise (Maximum) 5 mm (0.20 in.)
Fluid pressure at idle speed with valve closed 7,800 to 8,300 kPa (79.5 to 84.6 kgf/cm2 , 1,131 to 1,204 psi)
Fluid pressure at idle speed with valve fully open and turn the steering wheel to the full lock position 7,800 to 8,300 kPa (79.5 to 84.6 kgf/cm2 , 1,131 to 1,204 psi)

STEERING WHEEL 

STEERING WHEEL - SERVICE DATA

Steering effort at idle speed (Reference) 6.0 N*m (61 kgf*cm, 53 in.*lbf)

VANE PUMP 

VANE PUMP - SERVICE DATA

Vane pump shaft and vane pump housing oil clearance (Maximum) 0.07 mm (0.0028 in.)
Vane plate thickness (Standard) 1.405 to 1.411 mm (0.05531 to 0.05555 in.)
Clearance between the rotor groove and plate (Maximum) 0.03 mm (0.0012 in.)
Compression spring free length (Minimum) 29.2 mm (1.150 in.)
Vane pump rotating torque 0.27 N*m (2.8 kgf*cm, 2.4 in.*lbf)

POWER STEERING LINK 

POWER STEERING LINK - SERVICE DATA

Steering rack runout (Maximum) 0.3 mm (0.0118 in.)
Tie rod end sub-assembly stud bolt turning torque 0.98 to 3.92 N*m (10 to 40 kgf*cm, 8.7 to 34.7 in.*lbf)
Total preload (Control valve rotating torque) 1.5 N*m (15.3 kgf*cm, 13.3 in.*lbf) or less
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.