Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2007ES 350REPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEMPREPARATION2GR-FE ENGINE MECHANICALSST
2007 Lexus ES 350
2GR-FE Engine Mechanical: SST
2007 Lexus ES 350SECTION SST
2GR-FE ENGINE MECHANICAL - SST CHART
| 09032-00100 | Oil Pan Seal Cutter | |
| 09201-10000 | Valve Guide Bushing Remover & Replacer Set | |
| (09201-01050) | Valve Guide Bushing Remover & Replacer 5 | |
| 09201-41020 | Valve Stem Oil Seal Replacer | |
| 09202-70020 | Valve Spring Compressor | |
| (09202-00010) | Attachment | |
| 09213-70011 | Crankshaft Pully Holding Tool | |
| (09213-70020) | Bolt | |
| 09223-15030 | Oil Seal & Bearing Replacer | |
| 09223-22010 | Crankshaft Front Oil Seal Replacer | |
| 09228-06501 | Oil Filter Wrench | |
| 09276-75010 | Valve Litter Tool | |
| 09316-60011 | Transmission & Transfer Bearing Replacer | |
| (09316-00011) | Replacer Pipe | |
| 09330-00021 | Companion Flange Holding Tool | |
| 09506-35010 | Differential Drive Pinion Rear Bearing Replacer | |
| 09843-18030 | Tacho-pulse Pickup Wire No.2 | |
| 09843-18040 | Diagnosis Check Wire No.2 | |
| 09950-50013 | Puller C Set | |
| (09951-05010) | Hanger 150 | |
| (09952-05010) | Slide Arm | |
| (09953-05020) | Center Bolt 150 | |
| (09954-05021) | Claw No.2 | |
| 09950-70010 | Handle Set | |
| (09951-07100) | Handle 100 | |
| (09951-07150) | Handle 150 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.