2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Combination Meter: Installation

  1. INSTALL COMBINATION METER ASSEMBLY 
    1. Connect the 2 connectors as shown in the illustration.
      Fig 1: Connecting Connectors
      G05252884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the combination meter assembly as shown in the illustration.
      Fig 2: Installing Combination Meter Assembly
      G05252885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the 4 screws.
      Fig 3: Locating Combination Meter Assembly Screws
      G05252879Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 
    1. Engage the guide and 4 claws.
    2. Engage the 2 clips.
    3. Install the instrument cluster finish panel sub-assembly with the screw.
      Fig 4: Identifying Instrument Cluster Finish Panel Sub-Assembly Claws And Guide, Clips And Screw
      G05252878Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL STEERING COLUMN COVER 
    1. Engage the claw and install the upper steering column cover.
      Fig 5: Identifying Steering Column Cover Upper Claw
      G05252877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 2 claws.
    3. Install the lower steering column cover with the 2 screws.

      Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf) 

    4. Fig 6: Identifying Lower Steering Column Cover With Screws And Claws
      G05252889Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  6. INSTALL SIDE INSTRUMENT PANEL LH  (See INSTALLATION )
  7. INSTALL FRONT DOOR OPENING TRIM COVER LH  (See INSTALLATION )
  8. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  10. PERFORM INITIALIZATION 
    NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.