Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Back Sonar SW | Left side of dash. See Figure. |
| Brake Fluid Level Warning SW | Left rear of engine compartment. See Figure. |
| Door Courtesy SW (Front LH) | Left "B" pillar. See Figure. |
| Door Courtesy SW (Front RH) | Right "B" pillar. See Figure. |
| Door Courtesy SW (Rear LH) | Left "C" pillar. See Figure. |
| Door Courtesy SW (Rear RH) | Right "C" pillar. See Figure. |
| Engine Hood Courtesy SW | Front of engine compartment. See Figure. |
| Engine Oil Pressure SW | Left front of engine. See Figure. |
| Front Seat Inner Belt (LH) | In left front seat. See Figure. |
| Front Seat Inner Belt (RH) | In right front seat. See Figure. |
| Front Seat Outer Belt (LH) | Left "B" pillar. See Figure. |
| Front Seat Outer Belt (RH) | Right "B" pillar. See Figure. |
| Luggage Electrical Key SW | Rear of luggage compartment. See Figure. |
| Parking Brake SW | Left side of dash. See Figure. |
| Park/Neutral Position SW | On transmission assembly. See Figure. |
| Power Steering Oil Pressure SW | Right rear of engine compartment. See Figure. |
| Stop Lamp SW | Left side of dash. See Figure. |
| Washer Level Warning SW | In washer reservoir. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
