2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
A1 Behind left headlamp assembly. See Figure.
A2 Behind left headlamp assembly. See Figure.
A3 Behind right headlamp assembly. See Figure.
A4 Behind right headlamp assembly. See Figure.
A5 Left side of dash. See Figure.
A6 Right side of dash. See Figure.
B1 Center of engine. See Figure.
B2 Right rear of engine. See Figure.
B3 Right rear of engine. See Figure.
E1 Left side of dash. See Figure.
E2 Center of dash. See Figure.
E3 Right side of dash. See Figure.
E4 Center of dash. See Figure.
L1 Left "C" pillar. See Figure.
M1 Near right "C" pillar. See Figure.
M2 Behind right headlamp. See Figure.
N1 Right "C" pillar. See Figure.
R1 Behind left taillamp. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.