SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2007ES 350REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROLFRONT SPEED SENSORREMOVAL
2007 Lexus ES 350

Front Speed Sensor: Removal

2007 Lexus ES 350SECTION Removal

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. REMOVE FRONT WHEEL 
  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH  (See REMOVAL )
  3. REMOVE FRONT FENDER LINER  (See REMOVAL )
  4. REMOVE FRONT SPEED SENSOR 
    1. Disconnect the front speed sensor connector and clamp.
      Fig 1: Locating Front Speed Sensor Connector And Clamp
      G05250489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts from the body and the shock absorber assembly.
    3. Disengage the 2 claws from the steering knuckle and body.
      Fig 2: Locating Bolts And Claws
      G04978252Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the bolt and the front speed sensor.
      NOTE:
      • Prevent foreign matter from attaching to the sensor tip.
      • Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.