Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE
Rear Power Window Switch: Inspection
- INSPECT POWER WINDOW SWITCH (for Rear RH)
- Remove the power window switch.
- Measure the resistance when the switch is operated according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Switch Condition Specified Condition 2 (E) - 4 (A) - 5 (E) Auto UP Below 1 Ω 2 (U) - 5 (E) Manual UP Below 1 Ω 5 (E) - 10 (D) Manual DOWN Below 1 Ω 4 (A) - 10 (D) - 5 (E) Auto DOWN Below 1 Ω
- REMOVE POWER WINDOW SWITCH (for Rear LH)
- Remove the power window switch.
- Measure the resistance when the switch is operated according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Switch Condition Specified Condition 2 (E) - 4 (A) - 5 (E) Auto UP Below 1 Ω 2 (U) - 5 (E) Manual UP Below 1 Ω 5 (E) - 10 (D) Manual DOWN Below 1 Ω 4 (A) - 10 (D) - 5 (E) Auto DOWN Below 1 Ω
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.