Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Lexus ES 350FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
NOTE:
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn the courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
- CHECK DTC OUTPUT
- Turn the engine switch off.
- Wait for at least 10 seconds, and then turn the engine switch on (IG).
- Check whether the DTC output recurs.
Result
RESULT CHARTDisplay (DTC Output) Proceed to B2313 A No output B
B: END
A: Go to Next Step
- INITIALIZE SYSTEM (POWER WINDOW CONTROL SYSTEM)
- Turn the engine switch on (IG) and initialize the power window regulator motor (on the driver side) (See INITIALIZATION ).
- Turn the engine switch off.
- Wait for at least 10 seconds, and then turn the engine switch on (IG).
- Check whether the DTC output recurs.
Result
RESULT CHARTDisplay (DTC Output) Proceed to No output A B2313 B
B: REPLACE DRIVER SIDE POWER WINDOW REGULATOR MOTOR ASSEMBLY
A: END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
