How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the power window control system.
• The hand-held tester should be used in steps  3,  4 and  6.

1. VEHICLE BROUGHT TO WORKSHOP 
   1. Go to next step. 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See  CUSTOMER PROBLEM ANALYSIS CHECK   ) 
   1. Go to next step. 
3. INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN) 
   1. Use the hand-held tester to check if the Multiplex Communication System (MPX) is functioning normally.

      Result: 

      COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   1. B: Go to MULTIPLEX COMMUNICATION SYSTEM (See  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
   2. A: Go to next step. 
4. CHECK FOR DTC (See  DTC CHECK/CLEAR   ) 
   1. Check for DTC and note any codes that are output.
   2. Delete the DTC.
   3. Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Result: 

      DTC RESULT
      
      

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccurs	B

   1. B: Go to step   6 
   2. A: Go to next step. 
5. See  PROBLEM SYMPTOMS TABLE  

   Result: 

   PROBLEM SYMPTOMS RESULT
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   1. B: Go to step   7 
   2. A: Go to next step. 
6. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. See DATA LIST/ACTIVE TEST 
   2. See ON-VEHICLE INSPECTION 
   3. See INSPECTION 
   4. See TERMINALS OF ECU 
   1. Go to next step. 
7. ADJUST, REPAIR OR REPLACE 
   1. Go to next step. 
8. CONFIRMATION TEST 
   1. END