Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus RX 400h AWDFACTORY OEM SERVICE PROCEDURE
Multiplex Communication System DTCS
MULTIPLEX COMMUNICATION SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B1200 | MPX Body ECU Stop |
| B1205 | AFS ECU Communication Stop |
| B1206 | P/W Master Switch Communication Stop |
| B1208 | Passenger Side Outer Mirror ECU |
| B1209 | Driver Side Outer Mirror |
| B1213 | Tilt and Telescopic ECU Communication Stop |
| B1214 | Door System Communication Bus Malfunction (+B Short) |
| B1215 | Door System Communication Bus Malfunction (GND Short) |
| B1245 | Wiper ECU Communication Stop |
| B1248 | AVC-LAN Communication Impossible |
| B1262 | A/C ECU Communication Stop |
| B1266 | Instrument Panel System Communication Bus Malfunction (+B Short) |
| B1267 | Instrument Panel System Communication Bus Malfunction (GND Short) |
| B1271 | Combination Meter ECU Communication Stop |
| B1272 | Power Seat ECU Communication Stop |
| B1273 | Sliding Roof ECU Communication Stop |
| B1279 | Rain Sensor Communication Stop |
| B1281 | Airbag ECU Communication Stop |
| B1287 | Back Door ECU Communication Stop |
| B1294 | Immobilizer ECU Communication Stop |
| B1277 | Center Cluster Integration Panel ECU Communication Stop |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
