Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE
On-Vehicle Inspection
- INSPECT THROTTLE BODY
- Listen to the throttle control motor operating sounds.
- Turn the ignition switch ON.
- When turning the accelerator pedal position sensor lever, check the running sound of the motor. Also, check that there is no friction noise.
- Inspect the throttle position sensor.
- Connect the intelligent tester or OBD II scan tool to the DLC3.
- Turn the ignition switch ON.
- Check that the MIL is off.
- Check that the throttle valve opening percentage (THROTTLE POS) in the DATA LIST shows the standard value.
Standard throttle valve opening percentage: 60% or more
NOTE: When checking the standard throttle valve opening percentage, the transmission is in the neutral position. - Listen to the throttle control motor operating sounds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.