Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transfer Unit: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINALÂ CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- RAISE VEHICLEÂ NOTE: Make sure that the vehicle is securely supported.
- REMOVE TRANSFER CASE PROTECTORÂ
- Remove the 3 bolts and transfer case protector.
Torque: 28 N*m (290 kgf*cm, 21 ft.*lbf)Â
- DRAIN TRANSFER OILÂ
- Drain transfer oil (see TRANSFER OILÂ ).
- REMOVE FRONT PROPELLER SHAFT ASSEMBLYÂ
- Remove the front propeller shaft (See REMOVAL ).
- REMOVE REAR PROPELLER SHAFT ASSEMBLYÂ
- Remove the rear propeller shaft assembly (See REMOVAL ).
- REMOVE TRANSFER SHIFT LEVER ROD ASSEMBLYÂ
- Remove the clip, plate washer, wave washer and bushing, and disconnect the transfer shift lever rod.
- REMOVE BODY GROUND WIRE SUB-ASSEMBLYÂ
- Remove the bolt and disconnect the body ground wire from the transfer.
- REMOVE CROSSMEMBERÂ
- Support the transmission, as shown in the illustration.NOTE: Use a wooden block so not to damage the transmission oil pan.
- Remove the 8 bolts, 2 nuts and crossmember.
Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf) for boltÂ
74 N*m (750 kgf*cm, 54 ft.*lbf) for nutÂ
- Support the transmission, as shown in the illustration.
- DISCONNECT BREATHER HOSEÂ
HINT:
At the time of installation, assemble the clip to the position shown in the illustration.
- DISCONNECT VEHICLE SPEED SENSOR CONNECTORÂ
- DISCONNECT TRANSFER INDICATOR SWITCH CONNECTORÂ
- DISCONNECT MOTOR ACTUATOR CONNECTORÂ
- JACK UP TRANSFER ASSEMBLYÂ
- Using a transmission jack, support the transfer.
- REMOVE TRANSFER ASSEMBLYÂ
- Disconnect the wire harness from the transfer.
- Remove the 6 transfer adaptor rear mounting bolts.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Torque: 69 N*m (700 kgf*cm, 51 ft.*lbf)Â
- Pull out the transfer down and toward the rear.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
