Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Outline
The cruise control system is a constant vehicle speed controller which controls the opening angle of the engine throttle valve by the SW, and allows driving at a constant speed without depressing the accelerator pedal.
Set OperationÂ
When the ON-OFF SW is turned on, the systems starts preparations for cruise control and turns on the indicator light in the combination meter.
Set Speed ControlÂ
When the - SET SW is operated with the ON-OFF SW turned on during driving, the speed is controlled at a constant speed.
Coast ControlÂ
When the - SET SW is kept turned on during cruise control driving, the engine control module controls the throttle valve to decelerate the vehicle speed.
Every time the - SET SW is turned on instantaneously, the vehicle speed is decelerated by approx. 1.6 km/h.
Accel ControlÂ
When the + RES SW is kept turned on during cruise control driving, the engine control module controls the throttle valve to accelerate the vehicle speed.
Every time the + RES SW is turned on instantaneously, the vehicle speed is accelerated by approx. 1.6 km/h.
Resume ControlÂ
If the vehicle speed is within the low speed limit (Approx. 40 km/h, 25 mph) when canceling the cruise control, operation of the + RES SW accelerates the vehicle speed and resumes the level before canceling the cruise control.
Manual Cancel MechanismÂ
If any of the following signals are input during cruise control driving, the cruise control is canceled.
* The stop light SW is on
* The CANCEL SW is turned on
* The ON-OFF SW is turned off
* Gear is shifted from position 'D or 4' to other positions than them.
Auto Cancel FunctionÂ
If any of the following conditions are detected, the cruise control is canceled:
* Failure in the stop light SW wiring
* Abnormality in the vehicle speed signal
* Malfunction in the electronically controlled throttle parts
* When the vehicle speed gets slower than the low speed limit.
* When the vehicle speed falls to 16 km/h less than the set speed.
Overdrive FunctionÂ
The overdrive may be canceled if the vehicle travels on a upward slope during cruise control driving. When the throttle opening information indicates the hill climbing is finished after the overdrive is canceled, the vehicle returns to overdrive mode again as the overdrive return timer is completed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
