Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Transmission Wire: Replacement
CAUTION:
When working with FIPG material, perform the following:
- Using a razor blade and gasket scraper, remove all the old FIPG material from the gasket surfaces.
- Thoroughly clean all components to remove any loose material.
- Clean both sealing surfaces with a non-residue solvent.
- Apply FIPG in a continuous line width approximately 1 mm (0.04 in.) along the sealing surface.
- Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.
- DISCONNECT BATTERY NEGATIVE TERMINAL
- DRAIN AUTOMATIC TRANSMISSION FLUID
- Remove the drain plug, gasket and drain the ATF.
- Install a new gasket and the drain plug.
- Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
- REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSY NOTE: Some fluid will remain in the oil pan.
- Remove the 20 bolts, oil pan and gasket.
- Remove the 3 magnets from the oil pan.
- Examine particles in pan.
- Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the pan and on the magnets to guess at the type of wear which might be found in the transmission. Steel (magnetic) hellip bearing, gear and clutch plate wear
Brass (non-magnetic) hellip bushing wear
- Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the pan and on the magnets to guess at the type of wear which might be found in the transmission. Steel (magnetic) hellip bearing, gear and clutch plate wear
- REMOVE VALVE BODY OIL STRAINER ASSY
- Remove the 4 bolts and oil strainer.NOTE: Be careful as some fluid will come out of the oil strainer.
- Remove the 4 bolts and oil strainer.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
