Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Data List/Active Test
- DATA LIST
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch to the ON position and turn the hand-held tester on.
- Operate the hand-held tester according to the steps on the display and select "DATA LIST".
DATA LISTItem Measurement Item/ Range (Display) Normal Condition Diagnostic Note PUSH SW PUSH SW/OFF or ON OFF: Push switch is turned OFF ON: Push switch is turned ON - KEY SW KEY SW/OFF or ON OFF: Key switch is turned OFF ON: Key switch is turned ON - IG SW IG SW/OFF or ON OFF: IG switch is turned OFF ON: IG switch is turned ON - LOCK POS SW Lock position sensor/OFF or ON OFF: Steering lock shaft is unlocked ON: Steering lock shaft is locked - UNLOCK POS SW Unlock position sensor/OFF or ON OFF: Steering lock shaft is locked ON: Steering lock shaft is unlocked - INTLOCK CBL POS Unlock sensor/LOCK or UNLOCK LOCK: Interlock cable position is locked UNLOCK: Interlock cable position is unlocked - STEERING LOCK Steering lock/SET or UNSET SET: Steering lock is activated UNSET: Steering lock is not activated - IMMOBILIZER IMMOBILIZER/SET or UNSET SET: Immobilizer is activated UNSET: Immobilizer is not activated - CHECK (SECURITY) CHECK (SECURITY)/ABNOML or NORMAL ABNORMAL: Interior verification is abnormal NORMAL: Interior verification is normal - SECURITY COM ID Security communication ID/NG or OK NG: Security ECU communication ID verification is abnormal OK: Security ECU communication ID verification is normal - SECURITY B-CODE Security B code/NO REGD or REGD NO REGD: Security B code is not registered (for security ECU communication) REGD: Security B code is registered (for security ECU communication) - SHIFT POS P2SW/NOT P or P NOT P: Shift lever is not in P position P: Shift lever is in P position - - ACTIVE TEST
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch to the ON position and turn the hand-held tester on.
- Following the display on the hand-held tester, perform the "ACTIVE TEST".
ACTIVE TESTItem Vehicle Condition/Test Details Diagnostic Note SECURITY INDIC Security indicator/OFF or ON - METER CHIME Meter chime/OFF or ON - METER BUZZER Meter buzzer/OFF or ON - NOT P-POS WARN Not P-position warning/OFF or ON Confirm that all doors are closed. BRAK CABLE WARN Break cable warning/OFF or ON Confirm that all doors are closed. UNMATH KEY WARN Unmatch key warning/OFF or ON Confirm that all doors are closed. STUCK WARN Stuck steering warning/OFF or ON - Meter Chime Continuously Meter chime continuously/OFF or ON -
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
