Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Shift Paddle Switch: Installation
- INSTALL SHIFT PADDLE SWITCH
- Install the 2 shift paddle switches and 2 brackets with the 4 screws.
Torque: 1.7 N*m (17 kgf*cm, 15 in.*lbf)
NOTE: Make sure that the brackets are securely installed.
- Install the 2 shift paddle switches and 2 brackets with the 4 screws.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.