Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Engine Immobilizer DTCS
CERTIFICATION ECU DIAGNOSTIC TROUBLE CODE TABLE
| DTC | Description |
|---|---|
| DTC B2784 | Antenna Coil Open / Short |
| DTC B2785 | Communication Malfunction between ECUs Connected by LIN |
| DTC B2786 | No Response from Steering Lock ECU |
| DTC B2789 | No Response from ID BOX |
| DTC B278A | Short to GND in Immobilizer System Power Source Circuit |
| DTC B2790 | ID BOX EEPROM Malfunction |
| DTC B2791 | Communication Condition Failure between ECM |
ECM DIAGNOSTIC TROUBLE CODE TABLE
| DTC | Description |
|---|---|
| DTC B2799 | Engine Immobilizer System |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.