2006 Lexus IS 350FACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
AXLE TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Front wheel set bolt 103 1,050 76
Steering knuckle x Lower ball joint assembly 120 1,224 89
Steering knuckle x Tie rod assembly 65 663 48
Steering knuckle x Upper suspension arm 87 887 64
Steering knuckle x Front axle hub sub-assembly 69 702 51
Steering knuckle x Front disc brake caliper assembly 78 795 58
Steering knuckle x Speed sensor front: Bolt (A) 14 140 10
Steering knuckle x Speed sensor front: Bolt (B) 8.5 87 75 in.*lbf
Front drive shaft x Front axle hub nut 294 2,998 217
Rear wheel set nut 103 1,050 76
Rear drive shaft x Rear axle shaft nut 290 2,957 214
Rear axle carrier sub-assembly x Toe control link sub-assembly 70 714 52
No.2 rear suspension arm assembly x Stabilizer link assembly 27 275 20
Rear axle carrier sub-assembly x Rear axle hub & bearing assembly 70 714 52
Rear axle carrier sub-assembly x No.1 rear upper control arm assembly 161 1,642 119
Rear axle carrier sub-assembly x No.2 rear upper control arm assembly 70 714 52
Rear axle carrier sub-assembly x No.1 rear suspension arm assembly 95 969 70
Rear axle carrier sub-assembly x No.2 rear suspension arm assembly 161 1,642 119
Rear axle carrier sub-assembly x Parking brake cable assembly 8.0 82 71 in.*lbf
Rear axle carrier sub-assembly x Parking brake anchor block sub-assembly 76 775 56
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.