Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Crankshaft Position Sensor: Installation
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a coat of engine oil to an O-ring of the crankshaft position sensor.
- Install the crankshaft position sensor with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the crankshaft position sensor connector.
- INSTALL COMPRESSOR WITH PULLEY ASSEMBLY (See INSTALLATION )
- INSTALL DISCHARGE HOSE SUB-ASSEMBLY (See INSTALLATION )
- INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE (See INSTALLATION )
- INSTALL V-RIBBED BELT (See INSTALLATION )
- INSTALL REAR ENGINE UNDER COVER LH
- INSTALL ENGINE UNDER COVER
- INSTALL NO. 1 INLET AIR CLEANER (See INSTALLATION )
- INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
- CHARGE REFRIGERANT (See REPLACEMENT )
- WARM UP ENGINE (See REPLACEMENT )
- CHECK FOR LEAKAGE OF REFRIGERANT (See REPLACEMENT )
- REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
