Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus IS 350FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
- INSPECT POWER WINDOW REGULATOR MOTORÂ
- Remove the power window motor.
- Apply battery voltage to the motor connector according to POWER WINDOW REGULATOR MOTORÂ
.NOTE: Do not apply battery voltage to any terminals except terminals 1 and 2.
StandardÂ
POWER WINDOW REGULATOR MOTORMeasurement Condition Specified Condition Battery positive (+) --> Terminal 2 (U)
Battery negative (-) --> Terminal 1 (D)Motor gear rotates clockwise Battery positive (+) --> Terminal 1 (D)
Battery negative (-) --> Terminal 2 (U)Motor gear rotates counterclockwise Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NG: REPLACE POWER WINDOW REGULATOR MOTORÂ
OK: Go to next stepÂ
- CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK MASTER SWITCH)Â
- Disconnect the M7 and M3 connectors.
- Measure the resistance according to the value(s) in WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK MASTER SWITCHÂ
.
ResistanceÂ
WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK MASTER SWITCHTester Connection Condition Specified Condition M7-1 (UP) - M3-2 (U) Always Below 1 ohms M7-11 (DN) - M3-1 (D) Always Below 1 ohms M7-1 (UP) - Body ground Always 10 k ohms or higher M7-11 (DN) - Body ground Always 10 k ohms or higher
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLEÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
