Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
The intelligent tester can be used in steps  3,  4,  5,  7 and  11.
- VEHICLE BROUGHT TO WORKSHOPÂ
NEXT: Go To Next StepÂ
- CUSTOMER PROBLEM ANALYSISÂ
- Confirm problem symptoms.
NEXT: Go To Next StepÂ
- CHECK MULTIPLEX COMMUNICATION SYSTEMÂ
- Check for DTCs (See DTC CHECK/CLEAR ).
HINT:
The 4WD control ECU sends the signals from the indicator light to the gateway ECU via CAN communication, and the gateway ECU sends the signals to the combination meter assembly via the multiplex communication system (BEAN).
ResultÂ
DTC OUTPUT RESULTResult Proceed to DTC is not output A DTC is output B B: CHECK MULTIPLEX COMMUNICATION CIRCUITÂ
A: Go To Next StepÂ
- CHECK CAN COMMUNICATION SYSTEMÂ
- Check for DTCs (See DIAGNOSIS SYSTEMÂ ).
HINT:
The ECU of this system is connected to the CAN communication system.
Therefore before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
ResultÂ
DTC OUTPUT RESULTResult Proceed to DTC is not output A DTC is output B B: CHECK CAN COMMUNICATION CIRCUITÂ
A: Go To Next StepÂ
- CHECK DTCÂ
- Check for DTCs (See DTC CHECK / CLEARÂ
).
- Record the DTCs.
- Clear the DTCs.
- Recheck for DTCs.
- Reproduce the malfunction and check if the DTCs are output again.
ResultÂ
DTC OUTPUT RESULTResult Proceed to DTC is output A DTC is not output B DTCs are not output, and the malfunction cannot be reproduced or checked C B: GO TO STEP   10Â
C: SYMPTOM SIMULATIONÂ
A: Go To Next StepÂ
- Check for DTCs (See DTC CHECK / CLEARÂ
).
- DTC TABLEÂ
- Go to DIAGNOSTIC TROUBLE CODE TABLEÂ .
NEXT: Go To Next StepÂ
- CIRCUIT INSPECTIONÂ
NEXT: Go To Next StepÂ
- REPAIRÂ
NEXT: Go To Next StepÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
- HYDRAULIC TESTÂ
- Perform HYDRAULIC TESTÂ .
NG: REPAIR HYDRAULIC CIRCUITÂ
OK: Go To Next StepÂ
- PROBLEM SYMPTOMS TABLEÂ
- Go to PROBLEM SYMPTOMS TABLEÂ .
NEXT: Go To Next StepÂ
- CIRCUIT INSPECTIONÂ
NEXT: Go To Next StepÂ
- REPAIRÂ
NEXT: Go To Next StepÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
