2006 Lexus IS 250 AWDFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, engage the 6 claws and install the steering angle sensor to the spiral cable sub-assembly.
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR (See  INSTALLATION  ) 
  3. INSTALL STEERING COLUMN COVER (See  INSTALLATION  ) 
  4. INSTALL STEERING WHEEL ASSEMBLY (See  INSTALLATION  ) 
  5. INSTALL STEERING PAD (See  INSTALLATION  ) 
  6. INSTALL NO. 3 LOWER STEERING WHEEL COVER (See  INSTALLATION  ) 
  7. INSTALL NO. 2 LOWER STEERING WHEEL COVER (See  INSTALLATION  ) 
  8. INSPECT STEERING WHEEL CENTER POINT 
    1. Inspect the steering wheel center point.
  9. CONNECT BATTERY NEGATIVE TERMINAL (See  INSTALLATION  ) 
  10. INSPECT STEERING PAD (See  INSTALLATION  ) 
  11. INSPECT SRS WARNING LIGHT 

    HINT:

    (See PROBLEM SYMPTOMS TABLE )

  12. PERFORM INITIALIZATION 

    HINT:

    (See INITIALIZATION )

    Some systems need initialization after reconnecting the cable to the negative battery cable.

    Fig 1: Identifying Claws
    G04047724Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.