Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus GS 430FACTORY OEM SERVICE PROCEDURE
Service Data
3UZ-FE STARTING - SERVICE DATA
| Starter relay | 3 - 5 Specified resistance 10 MΩ or higher (when battery voltage is applied to terminals 1 and 2) |
| Starter cut relay | 3 - 5 Specified resistance 10 MΩ or higher (when battery voltage is applied to terminals 1 and 2) |
| Engine switch | 7 (SS1) - 5 (GND) / 2 (SS2) - 5 (GND) Specified resistance Not pushed: 10kΩ or higher Pushed: Below 1 Ω |
| Measurement condition Battery positive 11 (SWIL) - Battery negative 4 (COM) or 5 (GND) Battery positive 12 (INDS) - Battery negative 4 (COM) or 5 (GND) Battery positive 13 (INDW) - Battery negative 4 (COM) or 5 (GND) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
