2005 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Service Data

Service Data Table - Starting & Charging

Starter    
Rated voltage and output power 12 V 2.0 kW
No-load characteristics Current 100 A or less at 11.5 V
rpm 2,500 rpm or less
Brush length STD 15.0 mm (0.591 in.)
Minimum 9.0 mm (0.354 in.)
Spring installed load STD 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.9 to 6.2 lbf)
Minimum 12.7 N (1.3 kgf, 2.9 lbf)
Commutator  
Diameter STD 35.0 mm (1.378 in.)
Minimum 34.0 mm (1.339 in.)
Undercut depth STD 0.7 mm (0.028 in.)
Minimum 0.2 mm (0.008 in.)
Circle runout Maximum 0.05 mm (0.0020 in.)
Battery Specific gravity at 20°C (68°F) 1.25 to 1.29
Voltage at 20°C (68°F) 12.5 to 12.9 V
Generator Rated output 12 V 100 A
Rotor coil resistance at 20°C (68°F) 2.1 to 2.5 Ω
Slip ring diameter STD 12.8 to 14.4 mm (0.504 to 0.567 in.)
rush exposed length STD 1.5 to 11.5 mm (0.059 to 0.453 in.)
Voltage regulator Regulating voltage 13.2 to 14.8 V
Battery Specific gravity at 20°C (68°F) 1.25 to 1.29
Voltage at 20°C (68°F) 12.5 to 12.9 V
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.